Decorate Your Garden with Concrete Bird Bath: DIY Bird Bath Concrete
Start the work with the concrete bird bath bowls.
- Lay polyethylene film on a firm surface (a wooden board, a piece of metal).
- Put wet sand and form a little hill using it, so that the bird bath could accumulate water inside of it.
- Cover this little hill with a piece of polyethylene film and put a leaf (rhubarb, burdock, fern) on it.
- Make a solution. It should not be too liquid. You can either buy a ready-made concrete mixture at the hardware store or mix sand with cement by a ratio of 3 to 1. Such mixture should be diluted with water.
- This solution should be put on the leaf, thus a thickness of this layer should be about 2 cm in the middle and about 1 cm at the edges.
- Make a stand-support for liquid dish. For this purpose insert a piece of plastic pipe with a diameter of about 10 cm and the length of 10-15 cm into the center of the water dish. The pipe should be filled with cement solution.
- Cover the product with polyethylene film, leaving a gap for ventilation, and wait for its drying (at least 2-3 days).
Then just put off the polyethylene film and remove the leaf from the surface.
Here is main notification on bird bath designs. We have the finest substance for bird bath designs. Check it out for yourself! You can find DIY Bird Bath Concrete guide and view the latest Decorate Your Garden with Concrete Bird Bath in here.
Back to Decorate Your Garden with Concrete Bird Bath
